Circuito De Disparo Para Un Scr

ISSUE 5

Installation Instructions for the
SS400 Series Temperature Compensated
Hall-Effect Position Sensors

P K 88700

ABSOLUTE MAXIMUM RATINGS*

WARNING

Supply voltage
Voltageexternally
applied to output
Output ON current
Storage Temperature

PERSONAL INJURY
•= DO NOT USE these products as safety or
emergency stop devices, or in any other application
where failure of theproduct could result in personal
injury.
Failure to comply with these instructions could
result in death or serious injury.

-1 to +30 VDC
+30 VDC max. (OFF only)
-0.5 VDC min. (OFF or ON)See Table A.

-65 to +160°C (-85 to +320°F)
Magnetic flux
No limit. Circuit cannot be
damaged by magnetic
overdrive.
* Absolute maximum ratings are the extreme limits that the
device willwithstand without damage to the device.
However, the electrical and mechanical characteristics are
not guaranteed as the maximum limits (above
recommended operating conditions) are approached, nor
willthe device necessarily operate at absolute maximum
ratings.

CAUTION
ELECTROSTATIC DISCHARGE DAMAGE
This component is sensitive to electrostatic discharge
(ESD). Take normal ESD precautions inhandling this
product to prevent ESD-induced damage and/or
degradation.
Failure to comply with these instructions will
result in product damage.

TABLE A
Output Current
Absolute Limits
SupplySOLDERING/ASSEMBLY
Leads must be adequately supported during any
forming/ shearing operation to ensure that the leads
are not stressed inside the plastic case. Recommended PC board wavesoldering temperature is 250
o
o
to 260 C (482 to 500 F) for 3 seconds maximum.

Ouput Current

Voltage

Max, mA

-1 to 24

50

24 to 25

37

25 to 26

33

26 to 27

28

27 to 2824

28 to 29

19

29 to 30

15

OPERATING CHARACTERISTICS (over Operating Voltage and Temperature, unless otherwise noted)
Min.
3.8

Typ.

Supply voltage

Max.
30

Remarks
VDC...